Hellwig Sway Bar 5802 Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

REAR STABILIZER BAR

70-81 CAMARO & FIREBIRD

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

5802 ( R-5802 ) 02/15/07

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.-5/8”=120 ft. lbs

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK

TIRES.

NOTE: THIS UNIT IS DESIGNED TO REPLACE THE FACTORY INSTALLED REAR ANTI-SWAY BAR. OR AS

AN ADDITION IF THE VEHICLE WAS NOT EQUIPPED WITH A FACTORY REAR SWAY BAR.

NOTE: THIS KIT INCLUDES LOCKNUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFETR BE

ING STARTED BY HAND.

Locate holes in frame to mount frame

bracket using supplied 3/8-16 X 1” bolts.

2 3

559-734-7451 800-367-5480 FAX 559-734-7460

1 2 3

INSTALLATION INSTRUCTIONS REAR STABILIZER BAR 70-81 CAMARO & FIREBIRD Thank you for purchasing a quality Hellwig Product. PLEASE READ THIS INSTRUC

Page 2

559-734-7451 800-367-5480 FAX 559-734-7460 1. If equipped, remove factory sway bar. 2. Locate the pre-drilled holes in the subframe as shown i

Page 3

7. Lubricate d-bushings and place on end of sway bar as shown in photo (6). Attach d-bushings to spring plate with supplied u-plate and factory fas

Pas de commentaire

Hellwig Sway Bar 5802 Manuel d'utilisateur