Hellwig Sway Bar 55904 Manuel d'utilisateur télécharger pdf

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND

CHOCK TIRES.

NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST THE SWAY BAR, THE WEIGHT

OF THE VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD.

DO NOT RAISE THE VEHICLE BY THE FRAME.

NOTE: THIS UNIT IS DESIGNED AS A REPLACEMENT FOR THE FACTORY INSTALLED FRONT

ANTI-SWAY BAR OR AS AN ADDITION IF NOT EQUIPPED.

NOTE: THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH

AFTER BEING STARTED BY HAND.

INSTALLATION INSTRUCTIONS

FRONT STABILIZER BAR

1970-72 B-Body Mopar; 1970-74 E-Body Mopar

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION

5904 ( R-5904 ) 04/17/2007

559-734-7451 800-367-5480 FAX 559-734-7460

1 2 3

TORQUE TABLE BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.

Page 2

559-734-7451 800-367-5480 FAX 559-734-7460 1. If equipped, remove the factory installed anti sway bar and the mounting hardware. 2. Insert ba

Page 3

559-734-7451 800-367-5480 FAX 559-734-7460 8. Assemble end links as shown in photos 3&7 and diagram. Tighten end link nuts until bushings

Modèles reliés Sway Bar 5904

Pas de commentaire