Hellwig Sway Bar 7710 Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

7710 Rear Stabilizer Bar

Thank you for purchasing a quality Hellwig Product.

PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR

INSTALLATION

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK

TIRES.

NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST

BE ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE VEHICLE BY FRAME.

NOTE: THIS UNIT IS DESIGNED TO MOUNT TO THE REAR OF THE AXLE TUBES WITH THE ARMS OF THE

BAR TOWARD THE REAR OF THE VEHICLE. THE HUMP SHOULD TILT SLIGHTLY DOWNWARD.

NOTE: THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFTER BEING

STARTED BY HAND.

1. Remove spare tire from vehicle before beginning installation of sway bar.

2. As shown in photo 1, place D-shaped poly-bushings onto straight areas of the bar on each side of center hump.

After installing D-bushings onto bar, place U-plates on D-bushings. The sway bar will be installed with the hump

tilted down as shown in photo 7.

3. Place U-bolts on axle tubes next to casting as shown in photos 1, 2, & 6. When installing U-bolts, be sure to put

U-bolts under any brake lines, wires or hoses on the axle to avoid any possible damage.

4. Before installing saddle brackets, remove passenger side brake line from clip and reposition brake line so

that it will clear the saddle bracket as shown in photo 2. Secure brake line with tie strap.

5. Place saddle brackets on axle by inserting legs of U-bolts into the holes in saddle brackets. Saddle brackets must be

installed so that one leg of the saddle bracket is located on the cast center section with the leg just inside the raised

lip on the casting. See photos 1,2,& 6.

6. Raise bar and place D-bushings on saddle brackets by inserting legs of U-bolts through holes in U-plates. Install

flat washers and hex nuts provided on U-bolts. Do not use locknuts provided in kit on axle U-bolts. LEAVE

559-734-7451 800-367-5480 FAX 559-734-7460

Tie Strap

Brake Line

Clip

7710(R-7710) 07/09/10

Heat Shield

1 2 3

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS7710 Rear Stabilizer BarThank you for purchasing a quality Hellwig Product.PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFO

Page 2

6. Remove the 2 screws attaching the spare tire heat shield to the passenger side frame rail. Save for use later.7. Locate existing spare tire crossme

Page 3 - Passenger Side

13. Thread jam nut and hex nut on to threads of end link far enough to mount flat washers and bushings to the end of sway bar asshown in photo 5a. Att

Commentaires sur ces manuels

Pas de commentaire

Hellwig Sway Bar 7710 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Hellwig Sway Bar 7710. Hellwig Sway Bar 7710 User Manual [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Hellwig Sway Bar 7710